User:Piffpoof

hi there

This is the user page for PiffPoof. Our use of FreeCAD and our membership on this forum started as a project to document a 40 year old sailing boat. Lots of information about the boat and the work done on it over the last 10 years is available at https://maringret.wordpress.com/. This page describes our FreeCAD specific activities.

The builders no longer had drawings and the son of the owner of the boat building company doubted there ever were full drawings. Consequently the hull dimensions had to be measured and then a model constructed within the software, Modern software packages like FreeCAD offer many beneficial features like symmetry constraints but when the final measurement is a model that is "easy on the eye" much "massaging" of models and data is required.

We started by modeling the interior (it was easiest to measure) and quickly reached150 objects. We were barely started and so it was at that point that we started to realise that we would be swamped by the sheer complexity of the undertaking unless we could sub-divide the project and automate as much as possible.This also marked the point where we started to construct tools we needed to manage our complexity explosion.