Translations:Macro FCInfo/4/cs: Difference between revisions

From FreeCAD Documentation
(Created page with "===Použití=== Vyberete objekt nebo spustíte aplikaci a vyberete objekt a zobrazí se řada informací. Jeho výpočty založené na jednotce FreeCADu, což je '''mm''' pro...")
 
mNo edit summary
 
(One intermediate revision by one other user not shown)
Line 2: Line 2:
Vyberete objekt nebo spustíte aplikaci a vyberete objekt a zobrazí se řada informací.
Vyberete objekt nebo spustíte aplikaci a vyberete objekt a zobrazí se řada informací.
Jeho výpočty založené na jednotce FreeCADu, což je '''mm''' pro kažbý nový výběr, vrací vždy délku v '''mm''' a úhel v '''dekadických stupních'''.
Jeho výpočty založené na jednotce FreeCADu, což je '''mm''' pro kažbý nový výběr, vrací vždy délku v '''mm''' a úhel v '''dekadických stupních'''.

[[File:Macro FCInfo 06.png|200px|left|upper window]][[File:Macro FCInfo 07.png|200px|lower window]]

Latest revision as of 19:12, 16 December 2018

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Macro FCInfo)
Select an object and launch the application, or launch the application first and then select an object. The object is analyzed and a dialog opens showing the gathered information. With each new selection, the length unit is reset to '''mm''' and the angle unit to '''decimal degrees'''.
[[File:Macro FCInfo 06.png|900px|left|window]]

Použití

Vyberete objekt nebo spustíte aplikaci a vyberete objekt a zobrazí se řada informací. Jeho výpočty založené na jednotce FreeCADu, což je mm pro kažbý nový výběr, vrací vždy délku v mm a úhel v dekadických stupních.

upper window
upper window

lower window