Translations:Draft Wire/5/en

• To manually enter coordinates enter the X, Y and Z component, and press Enter after each. Or you can press the Enter point button when you have the desired values. It is advisable to move the pointer out of the 3D view before entering coordinates.
• Press R or click the Relative checkbox to toggle relative mode. If relative mode is on, coordinates are relative to the last point, if available, else they are relative to the coordinate system origin.
• Press G or click the Global checkbox to toggle global mode. If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the working plane coordinate system. introduced in version 0.20
• Press F or click the Filled checkbox to toggle filled mode. If filled mode is on, the created wire will have DataMake Face set to true and will have a filled face, provided it is closed and does not self-intersect. Note that a self-intersecting wire with a face will not display properly, for such a wire DataMake Face must be set to false.
• Press N or click the Continue checkbox to toggle continue mode. If continue mode is on, the command will restart after using Finish or Close, or after creating a closed wire by snapping to the first point of the wire, allowing you to continue creating wires.
• Press / or the Undo button to undo the last point.
• Press A or the Finish button to finish the command and leave the wire open.
• Press O or the Close button to finish the command and close the wire. A closed wire can also be created by snapping to the first point of the wire.
• Press W or the Wipe button to delete the segments already placed, but keep working from the last point.
• Press U or the Set WP button to adjust the current working plane in the orientation of the last segment.
• Press S to switch Draft snapping on or off.
• Press Esc or the Close button to finish the command.