Translations:Draft Pattern/3/cs: Difference between revisions

From FreeCAD Documentation
(Created page with "==Použití== # Vyberet objekt # V rozbalovacím pohledu -> Data: nastavte Vytvořit pochu na true abyste zajistili, že objekt bude mít plochy, kde bude vzor # V rozbalovac...")
 
No edit summary
Line 1: Line 1:
==Použití==
==Použití==
# Vyberet objekt
# Vyberte objekt
# V rozbalovacím pohledu -> Data: nastavte Vytvořit pochu na true abyste zajistili, že objekt bude mít plochy, kde bude vzor
# V rozbalovacím pohledu -> Data: nastavte Vytvořit pochu na true abyste zajistili, že objekt bude mít plochy, kde bude vzor
# V rozbalovacím pohledu -> Pohled -> Vzor: specifikujte šrafovací vzor pro vyplnění drátů
# V rozbalovacím pohledu -> Pohled -> Vzor: specifikujte šrafovací vzor pro vyplnění drátů

Revision as of 19:04, 10 November 2014

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft Pattern)
# Make sure the objects are closed and planar, and do not self-intersect.
# To close a [[Draft_Wire|Draft Wire]], a [[Draft_BSpline|Draft BSpline]], a [[Draft_CubicBezCurve|Draft CubicBezCurve]] or a [[Draft_BezCurve|Draft BezCurve]] set its {{PropertyData|Closed}} property to {{TRUE}}.
# To close a [[Draft_Circle|Draft Circle]] or a [[Draft_Ellipse|Draft Ellipse]] set its {{PropertyData|First Angle}} and {{PropertyData|Last Angle}} properties to the same value.
# Select the objects.
# Switch to the {{MenuCommand|View}} tab of the [[Property_editor|Property editor]].
# The {{PropertyView|Display Mode}} must be set to {{Value|Flat Lines}}.
# Select a {{PropertyView|Pattern}}.
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser pattern.
# The pattern is not displayed when the objects are selected. Deselect them to check the result.
# Optionally reselect the objects to change the pattern properties.

Použití

  1. Vyberte objekt
  2. V rozbalovacím pohledu -> Data: nastavte Vytvořit pochu na true abyste zajistili, že objekt bude mít plochy, kde bude vzor
  3. V rozbalovacím pohledu -> Pohled -> Vzor: specifikujte šrafovací vzor pro vyplnění drátů
  4. V rozbalovacím pohledu -> Pohled -> Velikost vzoru: specifikujte rozměr šrafovacího vzoru