Translations:Draft BezCurve/11/cs: Difference between revisions

From FreeCAD Documentation
(Created page with "==Omezení== * Tento nástroj ještě není obecnně dostupný. Bude zahrnut až v další verzi. (post v0.13) * Vlastnost Body se zatím nezaobrazuje v seznamu vlastností.")
 
No edit summary
 
Line 1: Line 1:
==Omezení==
==Omezení==
* Tento nástroj ještě není obecnně dostupný. Bude zahrnutv další verzi. (post v0.13)
* Tento nástroj je dostupný až od verze FreeCADu 0.14
* Vlastnost Body se zatím nezaobrazuje v seznamu vlastností.
* Vlastnost Body se zatím nezaobrazuje v seznamu vlastností.
* OpenCascade nepodporuje Bezierovy křivky se stupněm < 25. V praxi by to neměl být problém.

Latest revision as of 18:58, 10 June 2014

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft BezCurve)
* A Draft BezCurve can be edited with the [[Draft_Edit|Draft Edit]] command.
* OpenCascade, and therefore FreeCAD, does not support Bézier curves of degrees larger than 25. This should not be a problem in practice, as most users typically use Bézier curves of degrees 3 to 5.

Omezení

  • Tento nástroj je dostupný až od verze FreeCADu 0.14
  • Vlastnost Body se zatím nezaobrazuje v seznamu vlastností.
  • OpenCascade nepodporuje Bezierovy křivky se stupněm < 25. V praxi by to neměl být problém.