Translations:Arch Window/11/cs: Difference between revisions

From FreeCAD Documentation
(Created page with "* '''Jméno''': Jméno komponenty * '''Lomená čára''': Čárkami oddělený seznam lomených čar, na kterých je komponenta založena * '''Tloušťka''': Tloušťka vysunu...")
 
No edit summary
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
* '''Jméno''': Jméno komponenty
* '''Jméno''': Jméno komponenty
* '''Typ''': Typ komponenty. Může být "Frame" (Rám), "Glass panel" (Skleněný panel) nebo "Solid panel"(Pevný panel)
* '''Lomená čára''': Čárkami oddělený seznam lomených čar, na kterých je komponenta založena
* '''Dráty''': Čárkami oddělený seznam drátů, na kterých je komponenta založena
* '''Tloušťka''': Tloušťka vysunutí komponenty
* '''Tloušťka''': Tloušťka vysunutí komponenty
* '''Odsazení''': Vzdálenost mezi a její základovou 2D lomenou čárou(čárami)
* '''Odsazení''': Vzdálenost mezi komponentou a její základovou 2D lomenou čárou(čárami)

Latest revision as of 18:23, 15 May 2014

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Arch Window)
* '''Name''': A name for the component
* '''Type''': The type of component. Can be "Frame", "Glass panel", "Solid panel" or "Louvres"
* '''Wires''': A comma-separated list of wires the component is based on
* '''Thickness''': The extrusion thickness of the component
* '''Z Offset''': The distance between the component and its base 2D wire(s)
* '''Hinge''': This allows you to select an edge from the base 2D object, then set that edge as a hinge for this component and the next ones in the list
* '''Opening mode''': If you defined a hinge in this component or any other earlier in the list, setting the opening mode will allow the window to appear open or to display 2D opening symbols in plan or elevation.
  • Jméno: Jméno komponenty
  • Typ: Typ komponenty. Může být "Frame" (Rám), "Glass panel" (Skleněný panel) nebo "Solid panel"(Pevný panel)
  • Dráty: Čárkami oddělený seznam drátů, na kterých je komponenta založena
  • Tloušťka: Tloušťka vysunutí komponenty
  • Odsazení: Vzdálenost mezi komponentou a její základovou 2D lomenou čárou(čárami)