Translations:A2plus Workbench/12/zh-hans: Difference between revisions

Latest revision as of 13:48, 30 December 2019

Information about message (contribute)

This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.

Message definition (A2plus Workbench)

Assembling parts is done by adding constraints between parts. After a constraint A2plus will move the parts according to the constraint if possible.

通过在零件之间添加约束来将零件组装成部件。约束后，如果可能，A2plus将根据约束移动零件。
对于零件之间的复杂约束，A2plus可能无法解析。因此也可以参考故障排除部分中有关解决此类情况的策略。

Revision as of 13:46, 30 December 2019 (view source) Renoxray (talk \| contribs) No edit summary ← Older edit		Latest revision as of 13:48, 30 December 2019 (view source) Renoxray (talk \| contribs) No edit summary
Line 1:		Line 1:
	通过在零件之间添加约束来将零件组装成部件。约束后，如果可能，A2plus将根据约束移动零件。<br/>对于零件之间的复杂约束，A2plus可能无法解析。因此，也可以参考[[#Troubleshooting/zh-hans\|故障排除]]部分中有关解决此类情况的策略。		通过在零件之间添加约束来将零件组装成部件。约束后，如果可能，A2plus将根据约束移动零件。<br/>对于零件之间的复杂约束，A2plus可能无法解析。因此也可以参考[[#Troubleshooting/zh-hans\|故障排除]]部分中有关解决此类情况的策略。