Sketcher CreatePolyline/de: Difference between revisions

From FreeCAD Documentation
(Created page with "Dieses Werkzeug arbeitet wie das Linienwerkzeug, erstellt aber kontinuierliche Linien- und Kreisbogensegmente, die durch Vertices (Knoten) miteinander ver...")
(Created page with "''Ein Linienzug beginnend mit einer Linie, gefolgt von einem tangentialen Kreisbogen, einem senkrecht abgehenden Kreisbogen und einer abschließenden tangentialen Linie.''")
Line 11: Line 11:
[[Image:Sketcher_PolylineExample1.png|none]]
[[Image:Sketcher_PolylineExample1.png|none]]


''Ein Linienzug beginnend mit einer Linie, gefolgt von einem tangentialen Kreisbogen, einem senkrecht abgehenden Kreisbogen und einer abschließenden tangentialen Linie.''
''Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line''


==How to use==
==How to use==

Revision as of 22:31, 3 November 2018

Sketcher Linienzug

Menüeintrag
Sketch → Skizzengeometrien → Linienzug erstellen
Arbeitsbereich
Sketcher
Standardtastenkürzel
Keiner
Eingeführt in Version
-
Siehe auch
Sketcher Linie

Beschreibung

Dieses Werkzeug arbeitet wie das Linienwerkzeug, erstellt aber kontinuierliche Linien- und Kreisbogensegmente, die durch Vertices (Knoten) miteinander verbunden sind.

Beim Starten des Werkzeugs verwandelt sich der Mauszeiger in ein weißes Kreuz mit einem roten Linienzugsymbol. Die Koordinaten werden in Echtzeit in blau neben dem Zeiger angezeigt.

Ein Linienzug beginnend mit einer Linie, gefolgt von einem tangentialen Kreisbogen, einem senkrecht abgehenden Kreisbogen und einer abschließenden tangentialen Linie.

How to use

The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:

  1. Press the M key: the new segment is a line which is perpendicular to the previous segment.
  2. Press the M key again: the new segment is a line which is tangential to the previous segment.
  3. Press the M key again: the new segment is an arc which is tangential to the previous segment.
  4. Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
  5. Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
  6. Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
  • v0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
  • Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
  • Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
  • Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.