Sketcher: Vincolo Raggio

From FreeCAD Documentation
Revision as of 21:15, 21 December 2013 by Renatorivo (talk | contribs) (Created page with "Questo vincolo forza il valore del raggio di un cerchio o di un arco a un valore specifico. Si può vincolare solo un arco o un cerchio alla volta.")

Raggio

Posizione nel menu
PartDesign → Schizzo → Raggio
Ambiente
Schizzo, PartDesign
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Distanza, Orizzontale, Verticale

Questo vincolo forza il valore del raggio di un cerchio o di un arco a un valore specifico. Si può vincolare solo un arco o un cerchio alla volta.


Operation


Select an arc or circle in the sketch by clicking on is ( turns dark green to indicate selection).

Apply the constraint by clicking on the Constrain Radius icon in the Sketcher toolbar or selecting the Constrain radius menu item from the Sketcher constraints sub menu of the the Sketcher (or Part Design) menu item (depending upon which workbench is selected).

The radius is constrained to have its current value when the constraint is applied.
To change the constraint value either double click on the constraint in the 3D display (turning red indicates the constraint is currently selected) or by double clicking on the constraint in the Constraints panel of the Tasks tab of the Combo View.
This will bring up a pop-up window.

Enter the desired value for the radius into the pop-up window and click OK to set the value of the constraint.

The constraint value is set to the value entered in the pop-up window.