CAM ToolController: Difference between revisions
(Created page with "{{UnfinishedDocu}} A tool controller carries properties for how a tool should be used in one or more operations. For example a tool, like a 1/4 inch cutter can run at many d...") |
Renatorivo (talk | contribs) No edit summary |
||
Line 1: | Line 1: | ||
<languages/> |
|||
{{UnfinishedDocu}} |
{{Template:UnfinishedDocu}} |
||
<translate> |
|||
A tool controller carries properties for how a tool should be used in one or more operations. |
A tool controller carries properties for how a tool should be used in one or more operations. |
||
Line 17: | Line 19: | ||
Tool Number |
Tool Number |
||
</translate> |
|||
{{clear}} |
Revision as of 19:48, 14 August 2018
This documentation is not finished. Please help and contribute documentation.
GuiCommand model explains how commands should be documented. Browse Category:UnfinishedDocu to see more incomplete pages like this one. See Category:Command Reference for all commands.
See WikiPages to learn about editing the wiki pages, and go to Help FreeCAD to learn about other ways in which you can contribute.
A tool controller carries properties for how a tool should be used in one or more operations.
For example a tool, like a 1/4 inch cutter can run at many different spindle speeds and feed rates. The same tool might be used in different ways in the same job.
properties:
feed speed (h) feed speed (v)
rapid speed (h) rapid speed (v)
Spindle Speed (rpm) Spindle direction (forward/reverse)
Tool Number