Path Hélice

From FreeCAD Documentation
Revision as of 19:26, 29 October 2018 by Luc (talk | contribs) (Created page with "==Utilisation==")

Hélice

Emplacement du menu
Path → Helix
Ateliers
Path
Raccourci par défaut
Aucun
Introduit dans la version
-
Voir aussi
Aucun

Description

La commande Helix ajoute une opération d'interpolation hélicoïdale au travail. Sortie d'interpolation dans le sens horaire des hélices (G2), commandes G-Code. Sortie dans le sens antihoraire (G3) Commandes G-Code. Le pourcentage de dépassement spécifie le dépassement concentrique en pourcentage du diamètre de l'outil.

Utilisation

  • Select the Helix tool from the Path->menu, or the GUI Button, and press.
  • Choose a Tool controller from the pop-up selection dialogue window and confirm by pressing OK.
  • All available holes in the Job Model will be available for processing, listed in the Base Geometry tab. Confirm that the list matches the holes that are intended for processing, and adjust add, enable, or disable, as necessary. Holes can be added by selecting the wall faces of the Holes.
  • Ensure the Depths, Final Depth is correct, and adjust if not.
  • Ensure the Heights, Safe and Clearance Heights are correct, and adjust if not.
  • In the Operation tab, specify the Start From, Direction, and the Step Over percentage.