Part Torus/es: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Created page with "{{GuiCommand/es|Name=Part_Torus|Workbenches=Pieza,Completo}}")
Line 1: Line 1:
{{GuiCommand|Name=Part_Torus|MenuLocation=Part -> Torus||Workbenches=[[Part_Module|Part_Module]],Complete|SeeAlso=[[Part_CreatePrimitives|Part_CreatePrimitives]]}}
{{GuiCommand/es|Name=Part_Torus|Workbenches=Pieza,Completo}}


Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 parameters. The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of torus instead of a full one (they are set to 360° by default), the radius 1 and 2 define respectively the size of the hole and the ring thickness of the torus.
Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 parameters. The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of torus instead of a full one (they are set to 360° by default), the radius 1 and 2 define respectively the size of the hole and the ring thickness of the torus.

Revision as of 20:05, 20 February 2014

Part_Torus

Ubicación en el Menú
Ninguno
Entornos de trabajo
Pieza,Completo
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Ninguno

Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 parameters. The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of torus instead of a full one (they are set to 360° by default), the radius 1 and 2 define respectively the size of the hole and the ring thickness of the torus.