Part Torus/es: Difference between revisions
Emagdalena (talk | contribs) m (Languages in alphabetic order, except english that goes first) |
(Updating to match new version of source page) |
||
Line 1: | Line 1: | ||
{{GuiCommand |
{{GuiCommand|Name=Part_Torus|MenuLocation=Part -> Torus||Workbenches=[[Part_Module|Part_Module]],Complete|SeeAlso=[[Part_CreatePrimitives|Part_CreatePrimitives]]}} |
||
Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 parameters. The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of torus instead of a full one (they are set to 360° by default), the radius 1 and 2 define respectively the size of the hole and the ring thickness of the torus. |
|||
Crea un toro paramétrico simple, con los parámetros de posición, ángulo1, ángulo2, ángulo3, radio1 y radio2. El toro se posicionará en el origen (point 0,0,0). Los parámetros de ángulo permiten crear una porción del toro en lugar de uno completo (están establecidos como 360° por defecto), los radios 1 y 2 definen respectivamente el tamaño del agujero y del anillo del toro. |
|||
{{clear}} |
|||
{{languages/es | {{en|Part Torus}} {{fr|Part Torus/fr}} {{it|Part Torus/it}} }} |
|||
<languages/> |
Revision as of 20:03, 20 February 2014
Part_Torus |
Menu location |
---|
Part -> Torus |
Workbenches |
Part_Module,Complete |
Default shortcut |
None |
Introduced in version |
- |
See also |
Part_CreatePrimitives |
Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 parameters. The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of torus instead of a full one (they are set to 360° by default), the radius 1 and 2 define respectively the size of the hole and the ring thickness of the torus.