Part CheckGeometry/it: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
No edit summary
Line 1: Line 1:
{{GuiCommand/it|Name=Part CheckGeometry|Name/it=Controlla geometria‏‎|MenuLocation=Part → Controlla geometria|Workbenches=[[Part Workbench/it|Part]]|SeeAlso=}}
{{GuiCommand/it|Name=Part CheckGeometry|Name/it=Controlla geometria‏‎|MenuLocation=Part → Controlla geometria|Workbenches=[[Part Workbench/it|Part]]|SeeAlso=}}


==Introduction==
==Introduzione==
Lo strumento di controllo della geometria consente di verificare se si dispone di un solido valido
The check geometry tool allows you to verify if you have a valid solid


==Utilizzo==
==Utilizzo==


From the Part or Part Design WB
[[Category:UnfinishedDocu]]
Tools > Edit Parameters > Preferences > Mod > Part > CheckGeometry
then in the right pane double click under Value for the RunBOPCheck parameter and set to true


{{clear}}
{{clear}}

Revision as of 22:26, 25 January 2015

Controlla geometria‏‎

Posizione nel menu
Part → Controlla geometria
Ambiente
Part
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Nessuno

Introduzione

Lo strumento di controllo della geometria consente di verificare se si dispone di un solido valido

Utilizzo

From the Part or Part Design WB

Tools > Edit Parameters > Preferences > Mod > Part > CheckGeometry then in the right pane double click under Value for the RunBOPCheck parameter and set to true