PartDesign Workbench/id: Difference between revisions

From FreeCAD Documentation
(Created page with "Category:User Documentation/id")
(Updating to match new version of source page)
Line 42: Line 42:


{{PartDesign Placement}}
{{PartDesign Placement}}

== Tutorials ==
Only for a development version of FreeCAD that is not currently available as a binary or installer:
* [[PartDesign_Bearingholder_Tutorial_I|PartDesign Bearingholder Tutorial I]]
* [[PartDesign_Bearingholder_Tutorial_II|PartDesign Bearingholder Tutorial II]]


{{docnav/id|Workbenches/id|Mesh Workbench/id}}
{{docnav/id|Workbenches/id|Mesh Workbench/id}}

Revision as of 21:08, 26 May 2014

Part Design Workbench menyediakan peralatan untuk pemodelan komponen solid yang komplek dan ini berbasiskan pada Feature editing methodology. Workbench ini berhubungan erat dengan Sketcher Workbench.


Halaman wiki ini ditulus berdasarkan rilis freeCAD versi v0.13 version. Pada versi terdahulu peralatan pada Part Design belum lengkap atau bahkan belum tersedia. Untuk dapat menggunakan semua fitur Part Design, buka halaman Download dan perbaharui versi FreeCAD mu.

Basic Workflow

The sketch is the building block for creating and editing solid parts. The workflow can be summarized by this: a sketch containing 2D geometry is created first, then a solid creation tool is used on the sketch. At the moment the available tools are:

  • Pad which extrudes a sketch
  • Pocket which creates a pocket on an existing solid
  • Revolve which creates a solid by revolving a sketch along an axis
  • Groove' which creates a groove in an existing solid

More tools are planned in future releases.

A very important concept in the PartDesign workbench is the sketch support. Sketches can be created on standard planes (XY, XZ, YZ and planes parallel to them) or on the face of an existing solid. For this last case, the existing solid becomes the support of the sketch. Several tools will only work with sketches that have a support, for example, Pocket - without a support there would be nothing to remove material from!

After solid geometry has been created it can be modified with chamfers and fillets or transformed, e.g. mirrored or patterned.

The Partdesign workbench is meant to create a single, connected solid. Multiple solids will be possible with the Assembly workbench.

The Tools

The Part Design tools are all located in the Part Design menu that appears when you load the Part Design module.

They include the Sketcher Workbench tools, since the Part Design module is so dependent on them.

The Sketcher Tools

Template:Sketcher Tools

The Part Design Tools

Template:PartDesign Tools

Extras

Template:PartDesign Extras

Feature properties

Template:PartDesign Placement

Tutorials

Only for a development version of FreeCAD that is not currently available as a binary or installer:

Workbenches/id
Mesh Workbench/id