PartDesign SubtractiveBox/it: Difference between revisions
Renatorivo (talk | contribs) (Created page with "# Premere il pulsante {{KEY|24px '''Cubo sottrattivo'''}}. '''Nota''': Il Cubo sottrattivo fa parte di un menu di icone etichettato ''C...") |
Renatorivo (talk | contribs) (Created page with "== Opzioni ==") |
||
Line 18: | Line 18: | ||
# Nel corpo attivo viene visualizzata una funzione Cubo. |
# Nel corpo attivo viene visualizzata una funzione Cubo. |
||
== |
== Opzioni == |
||
The Box can be edited after its creation in two ways: |
The Box can be edited after its creation in two ways: |
Revision as of 15:48, 11 February 2018
Cubo sottrattivo |
Posizione nel menu |
---|
Part Design → Crea una primitiva sottrattiva → Cubo |
Ambiente |
PartDesign |
Avvio veloce |
None |
Introdotto nella versione |
- |
Vedere anche |
Primitive sottrattive |
Descrizione
Inserisce un cubo sottrattivo nel corpo attivo. La sua forma viene sottratta dal solido esistente.
disponibile dalla versione 0.17
On the left: active body (A) shown in grey and subtractive box (B) shown in transparent red; result on the right.
Utilizzo
- Premere il pulsante Cubo sottrattivo. Nota: Il Cubo sottrattivo fa parte di un menu di icone etichettato Crea una primitiva sottrattiva. Dopo aver avviato FreeCAD, il cubo sottrattivo è quella visualizzata nella barra degli strumenti. Se viene visualizzata una primitiva diversa, fare clic sulla freccia rivolta verso il basso accanto all'icona e selezionare Cubo sottrattiva
- Impostare i parametri della primitiva e Attachment.
- Cliccare OK.
- Nel corpo attivo viene visualizzata una funzione Cubo.
Opzioni
The Box can be edited after its creation in two ways:
- Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
- Via the Property editor.
Properties
- DatiAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
- DatiLabel: Label given to the Box object. Change to suit your needs.
- DatiLength: the Box's dimension in the X-direction.
- DatiWidth: the Box's dimension in the Y-direction.
- DatiHeight: the Box's dimension in the Z-direction.