PartDesign LinearPattern: Difference between revisions
Mrlukeparry (talk | contribs) m (→Options) |
|||
Line 7: | Line 7: | ||
==Options== |
==Options== |
||
[[Image:linearpattern_parameters.png|left]] |
[[Image:linearpattern_parameters.png|left]] |
||
When creating a linear pattern feature, the 'linear pattern parameters' |
When creating a linear pattern feature, the 'linear pattern parameters' dialog offers two different ways of specifying the pattern direction. |
||
===Standard axis=== |
===Standard axis=== |
||
Line 13: | Line 13: | ||
===Select a face=== |
===Select a face=== |
||
Pressing the button labeled 'Direction' allows to select a face or an edge from a pre-existing solid to specify the direction. The pattern direction will be normal to the face if a face is selected |
Pressing the button labeled 'Direction' allows to select a face or an edge from a pre-existing solid to specify the direction. The pattern direction will be normal to the face if a face is selected. Note that the button must be pressed again every time to select a new face or edge. |
||
===Select originals=== |
===Select originals=== |
Revision as of 14:50, 20 August 2012
PartDesign_LinearPattern |
Menu location |
---|
PartDesign -> LinearPattern |
Workbenches |
PartDesign, Complete |
Default shortcut |
None |
Introduced in version |
- |
See also |
None |
Introduction
'Make a linear pattern of features' - This tool takes a set of one or more selected features as its input (the 'originals'), and produces with it a second set of features translated in a given direction. For example:
Options
When creating a linear pattern feature, the 'linear pattern parameters' dialog offers two different ways of specifying the pattern direction.
Standard axis
One of the standard axes X, Y or Z can be chosen with the radio buttons. The pattern direction can be reversed by ticking 'Reverse direction'.
Select a face
Pressing the button labeled 'Direction' allows to select a face or an edge from a pre-existing solid to specify the direction. The pattern direction will be normal to the face if a face is selected. Note that the button must be pressed again every time to select a new face or edge.
Select originals
The list view shows the 'originals', the features that are to be patterned. Clicking on any feature will add it to the list.
Length and Occurrences
Specifies the length to be covered by the pattern, and the total number of pattern shapes (including the original feature). For example, six occurrences in a length of 150 would give a spacing of 30 between patterns (150 divided by 5, since there are 5 'gaps' between a total of six occurrences!).
Limitations
- Pattern shapes may not overlap one another except for the special case of only two occurrences (original plus one copy)
- Any pattern shapes that do not overlap the original's support will be excluded. This ensures that a PartDesign feature always consists of a single, connected solid
- For further limitations, see the mirrored feature