Draft Snap Endpoint/fr: Difference between revisions
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
| Line 11: | Line 11: | ||
#Choose element to be inserted into the FreeCAD-document |
#Choose element to be inserted into the FreeCAD-document |
||
#Move cursor near one of the endpoints you wish to attach your element to |
#Move cursor near one of the endpoints you wish to attach your element to |
||
# |
#Below on the right side of the cursor the symbol of the snap mode will appear |
||
# |
#Click to attach your element to the selected endpoint of target element |
||
===Notes=== |
===Notes=== |
||
Revision as of 16:31, 20 March 2016
|
|
| Emplacement du menu |
|---|
| Draft → Snap → Endpoint |
| Ateliers |
| Draft, Arch |
| Raccourci par défaut |
| Aucun |
| Introduit dans la version |
| - |
| Voir aussi |
| Aucun |
Description
This snap mode lets you select the endpoints of elements.
Use
- Make sure snap mode is turned on
- Choose element to be inserted into the FreeCAD-document
- Move cursor near one of the endpoints you wish to attach your element to
- Below on the right side of the cursor the symbol of the snap mode will appear
- Click to attach your element to the selected endpoint of target element
Notes
Snap mode can be used with
- sketcher elements (lines, arcs)
- draft elements (DWires, Lines, Arcs, Bezier Curves)
- edges of shapes
- edges of solids
Clicking on the snap-mode icon will toggle the snap mode on/off.