|Draft → Circle|
|Introduced in version|
The Circle tool creates a circle in the current work plane by entering two points, the center and the radius, or by picking tangents, or any combination of those. It uses the Draft Linestyle set on the Draft Tray. This tool works the same way as the Draft Arc tool, except that it stops after entering the radius.
How to use
- Press the button, or press then keys
- Click a first point on the 3D view, or type a coordinate
- Click a second point on the 3D view, or enter a radius value.
The circle can be turned into an arc after creation, by setting its first angle and last angle properties to different values.
- The primary use of the circle tool is by picking two points, the centre and a point on the circumference, defining the radius.
- By pressing , you can select a tangent instead of picking a point. You can therefore construct several types of circles by selecting one, two or three tangents.
- To enter coordinates manually, simply enter the numbers, then press between each X, Y and Z component.
- Press or click the checkbox to toggle continue mode. If continue mode is on, the Circle tool will restart after you finish the circle, allowing you to draw another one without pressing the tool button again.
- Press DataMake Face ); if not, the circle will not make a face (DataMake Face ). or click the checkbox to toggle filled mode. If filled mode is on, a the circle will create a filled face (
- Press snapping your point to the nearest snap location, independently of the distance. while drawing to force
- Press constrain your second point horizontally or vertically in relation to the first one. while drawing to
- Press or the button to abort the current command.
A Circle object shares all properties from a Draft Arc.
- DataFirst Angle: specifies the starting angle of the circle; normally 0°.
- DataLast Angle: specifies the ending angle of the circle; normally 0°.
- DataRadius: specifies the radius of the circle.
- DataMake Face: specifies if the Circle makes a face or not. If it is a face is created, otherwise only the circumference is considered part of the object. This property only works if the shape is a full circumference.
For it to be a full circle DataFirst Angle and DataLast Angle should have the same value; otherwise, a Draft Arc is created. The values 0° and 360° aren't considered the same, so if these two values are used, the circle will not form a face.
- ViewPattern: specifies a Draft Pattern with which to fill the face of the full circle. This property only works if DataMake Face is .
- ViewPattern Size: specifies the size of the Draft Pattern.
Circle = makeCircle(radius, placement=None, face=None, startangle=None, endangle=None, support=None) Circle = makeCircle(Part.Edge, placement=None, face=None, startangle=None, endangle=None, support=None)
- Creates a
Circleobject with given
radiuscan also be a
Curveobject must be a
- If a
placementis given, it is used.
True, the circle will make a face, that is, it will appear filled.
endangleare given (in degrees), and have different values, they are used and the object appears as a Draft Arc.
import Draft Circle1 = Draft.makeCircle(200) Circle2 = Draft.makeCircle(500) Circle3 = Draft.makeCircle(750)