|Draft -> Circle|
|Introduced in version|
The Circle tool creates a circle in the current work plane by entering two points, the center and the radius, or by picking tangents, or any combination of those. It takes the linewidth and color previously set on the Tasks tab.
How to use
- Press the button, or press then keys
- Click a first point on the 3D view, or type a coordinate
- Click a second point on the 3D view, or enter a radius value.
- The primary use of the circle tool is by picking two points, the centre and a point on the circumference, defining the radius.
- By pressing , you can select a tangent instead of picking a point. You can therefore construct several types of circles by selecting one, two or three tangents.
- To enter coordinates manually, simply enter the numbers, then press between each X, Y and Z component.
- Press or click the checkbox to check/uncheck the button. If continue mode is on, the Circle tool will restart after you give the second point, allowing you to draw another circle without pressing the Circle button again.
- Press snapping your point to the nearest snap location, independently of the distance. while drawing to force
- Press constrain your second point horizontally or vertically in relation to the first one. while drawing to
- Press or the button to abort the current Line command.
- DATARadius: The radius of the circle
The Circle tool can by used in macros and from the python console the following way:
import Draft myCircle = Draft.makeCircle(2)