Reinforcement UShapeRebar/es: Difference between revisions
(Created page with "==Utilización==") |
(Created page with "==Propiedades==") |
||
Line 21: | Line 21: | ||
# Click {{KEY|Cancel}} to exit the task panel |
# Click {{KEY|Cancel}} to exit the task panel |
||
== |
==Propiedades== |
||
* {{PropertyData|Orientation}}: It decides the orientation of the rebar (like a bottom, top, right and left). |
* {{PropertyData|Orientation}}: It decides the orientation of the rebar (like a bottom, top, right and left). |
Revision as of 12:29, 13 May 2018
Arch Rebar UShape |
Menu location |
---|
Arch → Rebar tools |
Workbenches |
Arch |
Default shortcut |
None |
See also |
LShape Rebar |
This command is part of the Reinforcement AddOn, that you can install via menu Tools → Addons Manager |
Descripción
The UShape Rebar tool allows user to create a UShape reinforcing bar in the structural element.
Utilización
- Create a structure element
- Select any face of the structure
- Then select UShape Rebar from the rebar tools
- A task panel will pop-out on the left side of the screen as shown below
- Select the desired orientation
- Give the inputs like front cover, right side cover, left side cover, bottom cover, top cover, rounding factor and diameter of the rebar
- Select the mode of distribution either amount or spacing
- If spacing is selected, a user can also opt for custom spacing
- Pick selected face is used to verify or change the face for rebar distribution
- Click OK or Apply to generate the rebars
- Click Cancel to exit the task panel
Propiedades
- DatosOrientation: It decides the orientation of the rebar (like a bottom, top, right and left).
- DatosFront Cover: The distance between rebar and selected face.
- DatosRight Cover: The distance between the right end of the rebar to right face of the structure.
- DatosLeft Cover: The distance between the left end of the rebar to the left face of the structure.
- DatosBottom Cover: The distance between rebar from the bottom face of the structure.
- DatosTop Cover: The distance between rebar from the top face of the structure.
- DatosRounding: A rounding value to be applied to the corners of the bars, expressed in times the diameter.
- DatosAmount: The amount of rebars.
- DatosSpacing: The distance between the axes of each bar.
Scripting
The UShape Rebar tool can by used in macros and from the python console by using the following function:
makeUShapeRebar(FrontCover, BottomCover, RightCover, LeftCover, Diameter, Topcover, Rounding, AmountSpacingCheck, AmountSpacingValue, Orientation, Structure, Facename)
- The UShape Rebar have four different orientations:
- Bottom
- Top
- Right
- Left
- Adds a UShape reinforcing bar object to the given structural object.
- If no Structure and Facename is given, it will take user selected face as input.
- Returns the new Rebar object.
Example: Creating UShape rebar.
import Arch, UShapeRebar
structure = Arch.makeStructure(length=1000.0, width=1000.0, height=400.0)
structure.ViewObject.Transparency = 80
FreeCAD.ActiveDocument.recompute()
rebar = UShapeRebar.makeUShapeRebar(20, 20, 20, 20, 8, 20, 4, True, 10, "Bottom", structure, "Face1")
Changing properties of UShape rebar.
import UShapeRebar
UShapeRebar.editUShapeRebar(rebar, 25, 25, 25, 25, 16, 25, 2, True, 15, "Top")