Sketcher: Rettangolo

From FreeCAD Documentation
This page is a translated version of the page Sketcher CreateRectangle and the translation is 27% complete.
Outdated translations are marked like this.

Rettangolo

Posizione nel menu
Sketch → Geometrie → Rettangolo
Ambiente
Sketcher
Avvio veloce
R
Introdotto nella versione
-
Vedere anche
Polilinea

Descrizione

Disegna un rettangolo definendo nella vista 3D due punti di vertice opposti.

Quando si avvia lo strumento, il puntatore del mouse assume la forma di croce bianca accompagnata dall'icona rossa di rettangolo.

Accanto al puntatore sono visualizzate, in blu, le coordinate della sua posizione, aggiornate in tempo reale.

To define a rectangle via a center point and an edge point, use the Centered rectangle tool.

Utilizzo

  • Dopo aver premuto il pulsante Rettangolo, selezionare il primo vertice nell'area della vista 3D, o su un oggetto esistente, poi spostare il puntatore e selezionare il vertice opposto. I vincoli automatici (auto constraints) si attivano nella scheda Azioni → Modifica controlli → Autovincoli del pannello Vista combinata.
  • Premere il tasto Esc, o cliccare sul tasto destro del mouse, per annullare l'operazione.

Notes

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.