View Revisions: Issue #3818

Summary 0003818: PartDesign Hole Depth Dimension should provide the option not to take the angled drill point type into account
Revision 2019-02-10 19:25 by normandc
Description In the PartDesign Hole feature, the Depth Dimension option controls the overall depth of a blind hole. When the Drill point option is set to Angled, the dimension includes the conical end point generated by the Angled drill point option.

There should be an option to set the depth dimension so that it does not include the conical end point, to comply with some standards.

http://euro.branly.free.fr/ISI/Construction/Dessin/filet/filets.htm
http://joho.p.free.fr/EC/COURS%20DOC/FILETAGE/REPRESENTATION/Cotation%20des%20filetages.pdf
Revision 2019-02-05 11:03 by LAROBERTE
Description The Drill Dimension (Depth Dimension) does not take into account the cone created by the "drill point type angled" function, but only the party with the nominal diameter.

http://euro.branly.free.fr/ISI/Construction/Dessin/filet/filets.htm
http://joho.p.free.fr/EC/COURS%20DOC/FILETAGE/REPRESENTATION/Cotation%20des%20filetages.pdf