Draft Trimex

From FreeCAD Documentation
Revision as of 04:20, 21 February 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Draft Trimex

Menyplacering
Draft -> Trim/Extend
Arbetsbänkar
Draft, Arch
Standard genväg
T R
Introducerad i version
-
Se även
Part Extrude

Beskrivning

Detta verktyg trimmar/klipper och förlänger linjer och polylines.

The Trimex tool also extrudes faces created from closed wires. In this sense, it's similar to Part Extrude and to PartDesign Pad.

Wire segment extended, then wire segment trimmed; face extruded into a solid body

Bruk

  1. Select a line that you wish to trim or extend, or select a face that you wish to extrude.
  2. Press the Draft Trimex button, or press T then R keys.
  3. Click a point in the 3D view, or enter a distance and press Enter.

Trimming or extending is decided from the position of the pointer.

  • If the line is short it can be extended to approach and cross another line.
  • If the line is long and crosses another line, the excess length can be trimmed.
  • If the pointer is moved over another object or edge, the trim-extend operation will snap to that object, so that the trimmed or extended line ends exactly at the intersection with the object. This snapping works even without Draft Snap modes active.

A Draft Wire allows you to trim or extend any of its individual segments, which may affect the entire shape of the wire. In this case, the Trimex tool will work on the line segment that is closer to the pointer. Hold the Shift key to keep trimming or extending the current segment independently of the position of the pointer.

When the selected object is a face, the Trimex tool switches to extrude mode. In extrude mode the extrusion is done in the direction of the normal of the face. For example, if a rectangle lies on the XY plane, it should be extruded in the Z direction. To do this correctly, pressing the Z key may be necessary to constrain the distance to the Z direction. Alternatively, hold the Shift key to extrude in any direction that is not the normal.

Options

  • trimning eller förlängning beslutas automatiskt beroende på muspositionen
  • om du flyttar musmarkören över ett annat objekt, så kommer trim/förläng operationen att snäppa till det objektet eller segmentet
  • Nedtryckning av SKIFT kommer att begränsa dig till det segment som för närvarande trimmas eller förlängs
  • Nedtryckning av ALT kommer att invertera trimningens ordning
  • fasning och avrundning stöds inte ännu men är planerat

Skript

There is no programming interface available for the Trimex tool. See the Part Extrude tool for extrusion of faces and other shapes.