Kreslení Zakrácení/Prodloužení

From FreeCAD Documentation
Revision as of 04:21, 21 February 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Kreslení Zakrácení/Prodloužení

Umístění Menu
Kreslení → Zakrácení/Prodloužení
Pracovní stoly
Kreslení, Architektura
Výchozí zástupce
T R
Představen ve verzi
-
Viz také
DílVysunutí

Popis

Tento nástroj zakracuje a prodlužuje přímky a lomené čáry a vysunuje plochy.

The Trimex tool also extrudes faces created from closed wires. In this sense, it's similar to Part Extrude and to PartDesign Pad.

Wire segment extended, then wire segment trimmed; face extruded into a solid body

Použití

  1. Vyberte drát, který chcete zakrátit nebo prodloužit nebo vyberte plochu, kterou chcete vysunout
  2. Stiskněte tlačítko Kreslení Zakrácení/Prodloužení nebo stiskněte klávesy T a potom R
  3. Klikněte na bod ve 3D pohledu

Trimming or extending is decided from the position of the pointer.

  • If the line is short it can be extended to approach and cross another line.
  • If the line is long and crosses another line, the excess length can be trimmed.
  • If the pointer is moved over another object or edge, the trim-extend operation will snap to that object, so that the trimmed or extended line ends exactly at the intersection with the object. This snapping works even without Draft Snap modes active.

A Draft Wire allows you to trim or extend any of its individual segments, which may affect the entire shape of the wire. In this case, the Trimex tool will work on the line segment that is closer to the pointer. Hold the Shift key to keep trimming or extending the current segment independently of the position of the pointer.

When the selected object is a face, the Trimex tool switches to extrude mode. In extrude mode the extrusion is done in the direction of the normal of the face. For example, if a rectangle lies on the XY plane, it should be extruded in the Z direction. To do this correctly, pressing the Z key may be necessary to constrain the distance to the Z direction. Alternatively, hold the Shift key to extrude in any direction that is not the normal.

Volby

  • zakracování nebo prodlužování je řízeno automaticky podle pozice myši
  • když posunete kurzor přes další objekt, operace zakrátit/prodloužit zachytí tento objekt nebo segment
  • stisknutí klávesy SHIFT vytvoří vazbu k segmentu, který je aktuálně zakracován nebo prodlužován
  • stisknutí klávesy ALT změní směr zakracování
  • pokud je vybraným objektem plocha nebo je vybrána plocha z existujícího objektu, nástroj Trimex se přepne do vysunovacího módu. Stisknutí klávesy SHIFT ve vysunovacím módu uvolní vysunutí z kolmice plochy a umožní zachycení k čemukoliv.

Skriptování

Není dostupné. Podívejte se na nástroj Díl vysunutí.